2014 Chrysler 200 Air Filter in Tucson , AZ

It sits in the engine bay inside a sealed plastic airbox ahead of the engine intake.

The V6 intake draws through a top-mounted panel filter housed in the airbox you’ll see near the front of the bay. Release the clips or screws to lift the cover and note filter orientation before removal. Tucson’s dusty roads can load filters faster, so periodic visual checks are smart. If you prefer a professional inspection, you can schedule service for a fast OEM-spec replacement.

• Access: top of engine bay, forward airbox
• Panels are clip/screw retained; avoid touching the MAF
• Quick checks available with a technician at our Tucson shop

It’s located behind the glove box, where it filters air entering the HVAC system.

Lower the glove box to access the rectangular filter door and slide the microfilter out. Because Tucson’s pollen and desert dust can accumulate quickly, a clean cabin filter helps airflow and reduces odors. If the glove box stops or side tabs make access tricky, our Mopar-trained team can replace it and check the blower path for debris—book a visit online.

• Behind-glove-box access panel for removal and install
• Improves HVAC airflow and cabin air quality
• Schedule an appointment for a quick swap

The engine filter cleans air for combustion, while the cabin filter cleans air for the HVAC and passengers.

The engine panel filter protects the 3.6‑liter V6 from dust that can affect performance and wear. The cabin microfilter traps pollen and fine dust before it reaches interior vents, improving comfort in Tucson’s desert climate. Both matter, but they serve different systems and live in different locations.

• Engine filter: intake protection for the 3.6L V6 (engine code 6VNAF3.6)
• Cabin filter: HVAC air quality for occupants
• Mopar OEM filters match factory fit and efficiency

Reduced power and mpg point to a dirty engine filter; weak airflow or musty odors suggest a clogged cabin filter.

In Arizona’s dusty conditions, filters can load up faster, causing hesitation or a rougher idle in severe cases. Inside the car, you may notice fan speeds feel lower than normal or detect a stale smell from the vents. If symptoms persist after a visual check, book an inspection so we can confirm the cause and restore airflow.

• Engine: sluggish acceleration or lower fuel economy
• Cabin: reduced HVAC airflow, odor, or haze on glass
• Schedule service or check service specials

Yes—many owners DIY the engine filter, while the cabin filter behind the glove box can be trickier; a dealer visit adds intake/MAF checks and OEM fit.

The engine filter is typically a straightforward panel swap; just seat the new element properly and re-latch the cover. The cabin filter may require releasing glove box stops and carefully fitting the new microfilter to avoid airflow whine. Our Mopar team also inspects the airbox seals and performs a visual MAF check.

• DIY-friendly: engine panel filter with basic tools
• Dealer value: OEM filter, intake seal and MAF visual
• Need help? Book an appointment

Yes—Larry H. Miller Chrysler Jeep Tucson installs Mopar OEM engine and cabin filters.

Genuine Mopar filters are engineered to Chrysler specifications for fit, filtration, and airflow. That helps the intake system seal correctly and supports HVAC performance in local conditions. If your vehicle runs E85 or gasoline, clean intake air is equally important—OEM filters help keep the 3.6L V6 breathing as designed.

• Mopar engine panel filter for factory-spec sealing
• Mopar cabin microfilter for HVAC air quality
• Installed by OEM-certified technicians in Tucson

Visit Larry H. Miller Chrysler Jeep Tucson, 7800 E 22nd St, Tucson, AZ 85710.

We’re your nearby Chrysler and Jeep service destination for the Greater Tucson area, including Catalina Foothills, Oro Valley, Marana, Sahuarita, Vail, and Drexel Heights. Use our online system to pick a time that fits your schedule, and we’ll install OEM-spec filters quickly and correctly.

• Corner of 22nd Street and Pantano
• Schedule service online in minutes
• See current service specials

Yes—a clogged engine air filter can reduce fuel economy and throttle response.

While modern engine management adapts to a point, a restricted panel filter adds intake resistance that can dull performance in the 3.6L V6. In dusty Tucson conditions or with frequent highway driving, inspect more often and replace when dirty. A fresh cabin filter won’t change mpg but will restore HVAC airflow.

• Inspect the engine filter at each oil change
• Use Mopar OEM to maintain designed airflow
• Book service for an intake and MAF check

Desert driving loads filters faster. Our factory-authorized Mopar Service Center supports drivers across Catalina Foothills, Oro Valley, Marana, Sahuarita, Vail, and Drexel Heights with precise air filter inspections and replacements that suit local conditions. Dust, monsoon-season debris, and spring pollen can restrict engine intake and HVAC airflow; we address both with OEM-spec parts and careful fitment checks. Visit us at 7800 E 22nd St, Tucson, AZ 85710, near 22nd Street and Pantano, for convenient access. Prefer to plan ahead? Use our online system to choose a time that works for you, and we’ll get you in and out efficiently. For questions about current offers, see our service specials, or schedule service now.

The engine intake on the 3.6‑liter V6 (engine code 6VNAF3.6) uses a panel-style filter inside a sealed airbox to protect the combustion path. The cabin uses a microfilter located behind the glove box to clean incoming HVAC air. Genuine Mopar filters match Chrysler’s factory dimensions, media, and sealing profiles for consistent airflow and filtration. Check your owner’s manual for OEM replacement intervals and shorten them if you frequently drive in dust, construction zones, or monsoon debris. Using E85 or gasoline does not change filter type, but clean intake air is always essential for performance. Bring your 2014 Chrysler 200 to Larry H. Miller Chrysler Jeep Tucson in Tucson for OEM-spec filter service — schedule service.

Our air filter service is straightforward and thorough: we inspect the engine air filter, replace it if contaminated, and reseat the airbox cover to factory spec. We inspect and, if needed, replace the cabin air filter behind the glove box to restore HVAC airflow. The technician checks the intake housing and ducting for cracks, loose clamps, and debris, then performs a visual MAF sensor check for contamination. Proper filter seating and seal integrity are verified before you go. Want to plan around your day? You can schedule service online anytime, and review current service specials before your visit. For directions, head to 7800 E 22nd St, Tucson, AZ 85710.